## Plant & Mycorrhiza Root Lengths

In greenhouse experiments where all of the roots of an experimental plant can be
collected and measured, then the grid-line intersect method (Giovannetti and Mosse,
1980) can be used to measure two important variables:

- Mycorrhizal root length—an estimate of the length of roots colonized by mycorrhizal fungi (convertable to percentage colonization when divided by plant root length).
- Plant root length—an estimate of the total length of roots produced by the plant.

**(FW1)**. Total mass of this sample should be no more than 0.1-0.2 grams.

**The remaining roots of the sample are weighed quickly (weight will decline rapidly as water evaporates) to obtain a measurement of fresh weight**

**(FW2)**.

**The remaining roots of the sample are weighed quickly (weight will decline rapidly as water evaporates) to obtain a measurement of fresh weight**

**(FW2)**.

(i) total number of intersects between lines and roots

**(R1)**

(ii) total number of intersects where the root is mycorrhizal

**(R2)**

**(DW2)**

**EXAMPLE:**In the illustration at right,

**R1**(root length) is 40 cm:

21 intersects (horizontal lines) + 19 intersects (vertical lines)

**EXAMPLE:**In the illustration at left,

**R2**(mycorrhizal root length) is 21 cm:

Intersects designated by red circles: 11 (horizontal) + 10 (vertical)

also: 21/40 = 53% colonization

The data above is used to calculate plant root length and mycorrhizal root length
of the
**total sample** based on the assumption that distribution of mycorrhizae in the
small pooled sample reflects the distribution of mycorrhizae throughout the entire
root system.

#####
**Dry weight of small sample stained to measure colonization (DW1)**

This calculation is performed by setting up a proportion and solving for x (DW1), as follows:

DW2/FW2 = x/FW1

(FW2)(x) = (FW1)(DW2)

x or DW1 = (FW1)(DW2)/FW2

##### Mycorrhizal root length in large (unstained) sample (R3)

This calculation is an estimate based on the actual measurement of mycorrhizal root length in the small stained sample (R2). Another proportion is set up and solved for x (R3), as follows:

R2/DW1 = x/DW2

(DW1)(x) = (R2)(DW2)

x or R3 = (R2)(DW2)/DW1

##### Total mycorrhizal root length =
**R2 + R3**

Total plant root length can be estimated by substituting R1 for R2 in the same set of calculations. This estimate is valid only if the root architecture in the small sample (which usually consists of only fine roots) resembles that of the rest of the root system—the large sample.

### References

Giovanetti, M. and B. Mosse. 1980. An evaluation of techniques for measuring vesicular
mycorrhizal infection in roots.
*New Phytologist* 97:447-453.